Community
I could swear that I've read somewhere about a setting (but I can't remmeber where I read it or where the setting is) that if the pipe diameter is smaller than x, display it as y. I would assume that goes for profiles as well as plans.
Don Ireland
Engineering Design Technician
If a reply solves your issue, please remember to click on "Accept as Solution". This will help other users looking to solve a similar issue. Thank you.
Please do not send a PM asking for assistance. That's what the forums are for. This allows everyone to benefit from the question asked and the answers given.
I jsut found one possibility. Are all pipes that have the same style assigned doing this?
If so, look at the pipe style definition.
Don Ireland
Engineering Design Technician
If a reply solves your issue, please remember to click on "Accept as Solution". This will help other users looking to solve a similar issue. Thank you.
Please do not send a PM asking for assistance. That's what the forums are for. This allows everyone to benefit from the question asked and the answers given.
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")