AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Distinguished Contributor
bruce.jordan
Posts: 254
Registered: ‎05-12-2005
Message 11 of 14 (170 Views)

Re: Pipe in Profile going in the wrong direction

11-09-2012 02:41 PM in reply to: henryosegueda

Ah, that really made it obvious what it is doing.

 

And just to verify, your alignment goes to at least the NE end of your pipe network (including rounding errors)? 

I don't see any labeling before station 100+00.

 

-Bruce

Active Contributor
henryosegueda
Posts: 39
Registered: ‎09-28-2006
Message 12 of 14 (167 Views)

Re: Pipe in Profile going in the wrong direction

11-09-2012 02:49 PM in reply to: bruce.jordan

Yes the pipe goes to the NE. Should I extend the alignment to go further?

 

The orignal plan was done in LDD and the alignment only went to station 100+00.

I extended it to include the existing pipe.

I don't show the station labels for the entire alignment.

 

 

Distinguished Contributor
bruce.jordan
Posts: 254
Registered: ‎05-12-2005
Message 13 of 14 (163 Views)

Re: Pipe in Profile going in the wrong direction

11-09-2012 02:52 PM in reply to: henryosegueda

I'd say to rule out the alignment being too short, extend it say 10' past the NE end.

If it's too short, you will get the results you are showing in your images.

 

-Bruce

Active Contributor
henryosegueda
Posts: 39
Registered: ‎09-28-2006
Message 14 of 14 (158 Views)

Re: Pipe in Profile going in the wrong direction

11-09-2012 03:01 PM in reply to: bruce.jordan

Problem solved!

 

I extended the alignment further and it works now.

The pipe and alignment were off by 0.0045

See image.

 

Thanks for your help.

 

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.