AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Mentor
MarkPendergraft
Posts: 385
Registered: ‎06-27-2005
Message 1 of 1 (97 Views)

Part Builder Question

97 Views, 0 Replies
12-15-2012 08:42 AM

I am trying to create a part that derives the automatic surface elevation from the center of the rim of the structure, rather than the center of the structure itset.  In most situations, the difference would be minimal, but not all.  For example, when a Type II Catch Basin is situated underneath the curb and spun so the grate is in the road (picture attached).  In this situation the center is a half foot higher than the rim.

 

I've been through the part builder tutorial and can't seem to figure out if there is a way to seperate the autolayout point and the insertion rim elevation point.  Does anyone have any experience, knowledge, or advice on this?

 

 

Thanks for the help.

-Mark

 

struct question.png

 

 

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.