Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I am running 2007 and want to know
where I can go to change my bearings to read S00..... instead of S0..... I need
to place a 0 in front of any degrees that is less than 10. Thanks in
advance
I suspect that you are up the creek on that
request. I may be proven wrong, but unless there is some way an Expression
can be used you will not have much luck.
I am running 2007 and want to know
where I can go to change my bearings to read S00..... instead of S0..... I
need to place a 0 in front of any degrees that is less than 10. Thanks in
advance
wfb wrote:
> Brian:
>
> I suspect that you are up the creek on that request. I may be proven
> wrong, but unless there is some way an Expression can be used you will
> not have much luck.
Dana had an article illustrating how to do that, I'm just too lazy to
look it up (I know how I file my stuff, not so sure about her...) 😉
I use the LIFO system. Then all I have to remember is about how far back.
Bill
"Jason Hickey" wrote in message
news:5523243@discussion.autodesk.com...
wfb wrote:
> Brian:
>
> I suspect that you are up the creek on that request. I may be proven
> wrong, but unless there is some way an Expression can be used you will
> not have much luck.
Dana had an article illustrating how to do that, I'm just too lazy to
look it up (I know how I file my stuff, not so sure about her...) 😉
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")