So I guess I'll just use ArcGIS to create my contours from a DEM since I get the fatal errorut of memory anytime i connect to or attempt to create surface from a DEM. Arcview doesn't have any problem whatsoever doing what I need to do. Going to enable the 3GB switch soon to try it out. In the past I would use Land Desktop 2008 to create surfaces and contours from DEM, but it's no longer on my machine. Any new tricks to get around this problem?
3GB switch is a good start. Upgrading to Windows 7 64-bit with more memory likely would help.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!