AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
*Landman
Message 1 of 1 (29 Views)

Organizing regions after design revisions

29 Views, 0 Replies
05-30-2005 01:41 PM
Good Day All.

Just wondering if it is possible to re-organize regions of a corridor
alignment.

example:

Lets say you sample a corridor from station 0 to 500 and apon viewing the
sections you insert a new region for a assembly that meets design
requirements between stations 000 to 200

Now when you view the corridor properties you have

region 1 from 200 to 500 (have to re-set the stations for this assembly)
region 2 from 000 to 200

Now picture a corridor a few km long. As more and more regions are required
the process becomes more complex.

I would like the ability to re-organize regions based on the stationing of
the corridor and not the region itself, or that the regions could organize
themselves based on when they occur during the corridor.

Sorry if this is hard to follow.

Robert Howell
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.