I am doing a car park design, but when I view it in the object viewer, with a code styleset including render materials, one of the two curbed islands is not hatching correctly and shoots off into space.
Both islands are created in the same way (alignment, profiled on a dummy surface, corridor with a curb assembly).
The top island shows correctly, the bottom one doesnt.
I have attached a picture.
I've seen this caused by overhangs. Check your assembly for anything that might cause an overhang and your Corridor properties for overhang correction.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!