AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

*Expert Elite*
Posts: 5,034
Registered: ‎12-15-2008
Message 1 of 2 (66 Views)

Mulitple targets not being honored

66 Views, 1 Replies
02-26-2014 07:36 AM

I had a corridor that I needed to change some of the subs from an overlay widen to a full depth reconstruction. prior to replacing the overlay sub the multiple targets set to nearest worked. and now they don not. I went through each region a reassigned the targets but the cooridor is not stretching when it should.


If I take out the additional tagets it works?


This is with 2013, is this a known issue?

Thank you

Joseph D. Bouza, P.E. (one of 'THOSE' People) Civil 3D 2012 & 2013
HP Z210 Workstation
Intel Xeon CPU E31240 @ 3.30 Hz
12 GB Ram

Note: Its all Resistentialism, so keep calm and carry on

64 Bit Win7 OS
Product Support
Posts: 34
Registered: ‎07-12-2013
Message 2 of 2 (33 Views)

Re: Mulitple targets not being honored

02-27-2014 04:23 PM in reply to: Joe-Bouza

Hi Joseph,


Can you clarify which subs you are using and swapping? I see 4 potential overlay subs. Which one for full depth reconstruction?


Would it be possible to get a screen shot of the subs? Or even better, a copy of the drawing where you swapped these subs?

Willy Campbell
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.