I've been looking for one too. I can't say I've found one. I started making alignments for each layer of reinforcement which is very tedious and I don't recommend it.
I did a project with an MSE wall recently and built the wall using generic links. I did not model the tiebacks if that is what you need.
I used a preliminary corridor to establish the toe-of-wall and top-of-wall profiles and alignments. I can send you the road and wall assembly but it is pretty simple: From the shoulder a link width-and-slope targets the toe of wall, then a link slope-to-elevation targets the top-of-wall profile at a constant 1:6. Then a link-to-marked-point targets a previously-marked point on the road shoulder to finish off the top of the wall.
I used a separate corridor to develop the wall excavation volume.
Hello, Jeff, I saw your post abbout the MSE wall , im trying to draw an mse retaing wall project, I been looking around if there is a lisp or a program that does that, any luck in your side?
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!