AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Valued Contributor
HorizontalCurveGuy
Posts: 55
Registered: ‎03-31-2011
Message 1 of 1 (48 Views)

Metric - Imperial Mill and Overlay 2 point codes

48 Views, 0 Replies
07-15-2014 05:44 AM

I don't work in metric and have been helping someone with their issue, and belive the problem is in the point codes.

The issue is when they attach a sub assemblt to the outside of the OM2 regardless of targets the right side attaches to the left side in the corridor and section view. the metric OM2 point code, I belive is attaching to the bottom of the overlay no the top. does anyone know whats up with that?

 

Note the overlay point codes of the imperial and metric?

 

Imperial OM2 point codes

imperialOM2.png

 

Metric OM2 point code

metricOM2.png

 

 

 

OM@ metric section

om2section.png

OM@ metric assembly

om2assMet.png

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.