AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
*Expert Elite*
rkmcswain
Posts: 3,448
Registered: ‎11-13-2006
Message 1 of 4 (415 Views)

Linetypes for pipes in profile (TOP and BOTTOM line)

415 Views, 3 Replies
06-06-2011 09:25 AM

Requirement is to display pipes in profile with the same linetype ON TOP as shown in plan view, but bottom line of pipe must be continuous linetype.

 

Same problem as described here, 5 years ago ( http://forums.autodesk.com/t5/AutoCAD-Civil-3D/Pipes-linetypes/m-p/1573946 )

 

Has anything changed? I still do not see a way to control top and bottom pipe linetypes independently - using 2011.

 

 

*Expert Elite*
rkmcswain
Posts: 3,448
Registered: ‎11-13-2006
Message 2 of 4 (280 Views)

Re: Linetypes for pipes in profile (TOP and BOTTOM line)

07-16-2012 07:41 AM in reply to: rkmcswain

I don't see any change regarding this in 2013, am I overlooking something?

 

Thanks.

*Expert Elite*
mathewk
Posts: 2,753
Registered: ‎07-09-2003
Message 3 of 4 (277 Views)

Re: Linetypes for pipes in profile (TOP and BOTTOM line)

07-16-2012 08:49 AM in reply to: rkmcswain
You would need to trace a polyline on top of the invert and give it a continuous linetype.
Matt Kolberg
Cansel - Autodesk Division
http://www.cansel.ca/
*Expert Elite*
rkmcswain
Posts: 3,448
Registered: ‎11-13-2006
Message 4 of 4 (275 Views)

Re: Linetypes for pipes in profile (TOP and BOTTOM line)

07-16-2012 09:09 AM in reply to: mathewk

Thanks Matt. That is what everyone has been doing for SIX years now. 

I was hoping I was overlooking a new option in 2013.

By this point, I guess there is little hope it will ever be added.

Kind of ruins the whole automation thing when you have to edit the manually drawn line if and when an elevation changes.

 

 

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.