AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Valued Contributor
rcallison
Posts: 71
Registered: ‎11-07-2012
Message 1 of 4 (98 Views)

LINEAR PANEL RELEASE

98 Views, 3 Replies
09-17-2013 10:00 AM

We have a Civil 3D project created in Civil 3D ver 2012.  We recently upgraded to Rel 2014.  I opened a cross section file and it completely blew out al the C3D opjects.  All sections, existing ground and storm pipes are gone. Is ther any way to recover the drawing? I restored the original version of the section sheet but the cross sections are not there.

*Expert Elite*
TRogers
Posts: 1,390
Registered: ‎09-05-2007
Message 2 of 4 (93 Views)

Re: LINEAR PANEL RELEASE

09-17-2013 10:23 AM in reply to: rcallison

Are there any data shortcuts?

If the issue was resolved by this method, please click on "Accept As Solution"
*Civil 3DJ*
Todd Rogers

Visit my blog here.

     
Valued Contributor
rcallison
Posts: 71
Registered: ‎11-07-2012
Message 3 of 4 (84 Views)

Re: LINEAR PANEL RELEASE

09-17-2013 10:38 AM in reply to: TRogers

Yes, Data shortcuts were used

*Expert Elite*
TRogers
Posts: 1,390
Registered: ‎09-05-2007
Message 4 of 4 (82 Views)

Re: LINEAR PANEL RELEASE

09-17-2013 10:41 AM in reply to: rcallison

Try opening up the drawings that are data shortcut in and save them.  Then reopen the drawing and synchronize everything.  You might want to try just synchronizing before doing the aforementioned.

If the issue was resolved by this method, please click on "Accept As Solution"
*Civil 3DJ*
Todd Rogers

Visit my blog here.

     
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.