Hello,
I have created a pipe network and a couple of the manholes have laterals coming in at 90 degrees to the main line. I haven't been able to get these to show up in my profile views although they are listed in the manhole invert labels.
Any help is appreciated.
Solved! Go to Solution.
Solved by Jeff_M. Go to Solution.
Hi Jeff,
Thanks for the response.
I discovered that I had "Enable Part Masking" checked. After unchecking the pipe displays. Now my mainline pipes extend into the manhole. (see attached). I guess there's no way to display only the lateral pipe in the manhole.
BTW I'm using C3D 2012.
I'm betting the OP intiated the "Draw Parts in Profile View" command and drew the laterals in the PV, rather than letting the manhole show them automatically using your technique. If so, take the laterals out of the profile view and let the manhole display them for you. In that manner you can use profile masking.
I did use "draw parts in profile view". I removed these as suggested they now display, however there is a 90 degree bend in the alignment and the pipes do not show up in this manhole if masking is on.
Is there another way?
Thanks.
The lateral should still show up in the profile view, provided that it is connected to the manhole. Check to make sure the lateral shows up in the Structure properties Connected Pipes tab. Also, make sure the alignment PI is EXACTLY on the manhole's insertion point... sometimes that makes a difference. The last possibility is that the lateral pipe's invert is at some wildly erroneous elevation.
Also, run an Audit and see if the lateral pipe is, for some reason, bogus and gets erased.
Thanks for the help. I created a new drawing and made a pipe network using the same styles. and everything displays as it should..
I struggled with this problem for quite some time, thinking that it was a pipe style, then a profile view setting that was preventing my laterals from not showing up, but here was the problem, since I could not find anyone with a solution to this online.
Edit structure (not pipe) style, under Display Tab, view direction set to Profile, ensure that 'Structure Pipe Outlines' is turned ON.
If you followed sjg's suggestion (2 previous posts) you would have fond he provided the solution...