Labeling Station Range of Assemblies Used in Corridor in Model Space

[Grimes_MG]

Anyone been able to figure out how to have C3D provide the Station range informaiton of each of the assemblies used in a Corridor? I'd like to have the information shown in the Prospector (Name of Assembly, Region, Station Start and End) show in model space next to each assembly. This would be particularly useful when providing Typical Sections on plans. Thanks.

[Joe-Bouza]

I'm guessing you are looking for something other than naming the assembly such as.

[Joe-Bouza · Accepted solution]

Not sure if you know about this technique:
http://www.youtube.com/watch?v=aDkz0T_cvKg

[Grimes_MG]

Thanks Joe, that's what I was looking for and I'll see if it will also provide the Station Begin and End properties. I always forget about the MTEXT variables for some reason.