AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Member
MJR_PE
Posts: 6
Registered: ‎07-12-2013
Message 1 of 3 (239 Views)

Intersection with multiple assemblies

239 Views, 2 Replies
11-06-2013 03:03 PM

I have a super-e road assembly as shown that is running into the intersection of a future road stub.  I can not figure out how to get the sidewalk to grade out in the intersection transition I have created for the curb return. Does anyone know a way to get throught this situation? Any ideas would be greatly appreciated. Thanks in advance. 

*Expert Elite*
sboon
Posts: 2,133
Registered: ‎11-08-2005
Message 2 of 3 (207 Views)

Re: Intersection with multiple assemblies

11-06-2013 07:15 PM in reply to: MJR_PE

If you're just trying to get the contours looking right then featurelines and grading objects are probably going to be your best choice.  Extract the back of curb line from your corridor.  Draw two more featurelines for the edges of the ramp from the curb up to the corridor sidewalk.  Finish up with a few gradings etc.

 

Steve
Please use the Accept as Solution or Kudo buttons when appropriate

Valued Mentor
fcernst
Posts: 1,104
Registered: ‎01-07-2011
Message 3 of 3 (161 Views)

Re: Intersection with multiple assemblies

11-07-2013 12:44 PM in reply to: MJR_PE

Implement a Conditional subassembly into the curb return assembly.

Fred Ernst, PE
C3D 2015
Ernst Engineering
www.ernstengineering.com
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.