AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Active Member
Posts: 6
Registered: ‎07-12-2013
Message 1 of 3 (244 Views)

Intersection with multiple assemblies

244 Views, 2 Replies
11-06-2013 03:03 PM

I have a super-e road assembly as shown that is running into the intersection of a future road stub.  I can not figure out how to get the sidewalk to grade out in the intersection transition I have created for the curb return. Does anyone know a way to get throught this situation? Any ideas would be greatly appreciated. Thanks in advance. 

*Expert Elite*
Posts: 2,226
Registered: ‎11-08-2005
Message 2 of 3 (212 Views)

Re: Intersection with multiple assemblies

11-06-2013 07:15 PM in reply to: MJR_PE

If you're just trying to get the contours looking right then featurelines and grading objects are probably going to be your best choice.  Extract the back of curb line from your corridor.  Draw two more featurelines for the edges of the ramp from the curb up to the corridor sidewalk.  Finish up with a few gradings etc.


Please use the Accept as Solution or Kudo buttons when appropriate

Posts: 1,168
Registered: ‎01-07-2011
Message 3 of 3 (166 Views)

Re: Intersection with multiple assemblies

11-07-2013 12:44 PM in reply to: MJR_PE

Implement a Conditional subassembly into the curb return assembly.

Fred Ernst, PE
C3D 2015 SP2
Ernst Engineering
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.