I want to try the point inverse report but I am stumped on how to get
to this dialog box?
I type 'cogo' and get to a cogo traverse box but nothing shows up about inverse report.
Is there a non-ribbon method?
Im so green at the ribbon that I type "ribbon" but still cant find it
You can use that COGO dialog to get the report you want.
Easy way I have found is to draw a polyline through the points in the inverse. Snap to the nodes.
Upper left is an icon for Load Traverse from Polyline. The inverse data will fill the bottom of the dialog.
Back at the top, be sure it says No Adjustment in the Adjustment and Balance Rules pulldown. The next button to the right is Display Traverse Adjustment and Closure Reports. Because you selected No Adjustment, this will be an inverse of your points.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!