AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Valued Contributor
caddie99
Posts: 53
Registered: ‎06-09-2010
Message 1 of 3 (187 Views)

how to get to "cogo input dialog box" - I dont use the ribbon , using c3d2012 64

187 Views, 2 Replies
10-29-2012 04:33 PM

I want to try the point inverse report but I am stumped on how to get

to this dialog box?

I type 'cogo' and get to a cogo traverse box but nothing shows up about inverse report.

Is there a non-ribbon method?

Im so green at the ribbon that I type "ribbon" but still cant find it

 

*Expert Elite*
tcorey
Posts: 2,646
Registered: ‎12-18-2002
Message 2 of 3 (185 Views)

Re: how to get to "cogo input dialog box" - I dont use the ribbon , us

10-29-2012 04:52 PM in reply to: caddie99

You can use that COGO dialog to get the report you want.

 

Easy way I have found is to draw a polyline through the points in the inverse. Snap to the nodes.

 

Type COGO.

 

Upper left is an icon for Load Traverse from Polyline. The inverse data will fill the bottom of the dialog.

 

Back at the top, be sure it says No Adjustment in the Adjustment and Balance Rules pulldown. The next button to the right is Display Traverse Adjustment and Closure Reports. Because you selected No Adjustment, this will be an inverse of  your points.

Tim Corey, Owner
Delta Engineering Systems
Redding, CA
Autodesk Authorized Value-Added Reseller
Valued Contributor
caddie99
Posts: 53
Registered: ‎06-09-2010
Message 3 of 3 (154 Views)

Re: how to get to "cogo input dialog box" - I dont use the ribbon , us

10-30-2012 07:15 AM in reply to: tcorey

Thanks,  but I need point numbers in my report to satisfy the County surveyor.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.