AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Contributor
zakaqamar
Posts: 15
Registered: ‎03-30-2009
Message 1 of 2 (135 Views)

How to create assembly and attaching to fixed ROW .

135 Views, 1 Replies
09-28-2013 12:47 PM

I have 30 M corridor. daylighting slopes have not been mentioned in typical section of  this urban road. the sketch is shown. can any body help me making this assembly and to get the 30 m fixed corridor.

 

Regards

*Expert Elite*
sboon
Posts: 2,176
Registered: ‎11-08-2005
Message 2 of 2 (104 Views)

Re: How to create assembly and attaching to fixed ROW .

09-28-2013 09:05 PM in reply to: zakaqamar

 You don't say which version you're using but you could use either LaneOutsideSuper or LaneSuperelevationAOR then BasicCurb followed by UrbanSidewalk.  For the final piece I suggest LinkOffsetOnSurface.  That will allow you to tie the section to the existing surface at the 15m boundary without a specified slope.

 

Steve
Please use the Accept as Solution or Kudo buttons when appropriate

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.