How do I add Gabbion Wall to my assembly in Civil 3D?

[sb208918]

I have been trying to add a gabbion wall to my assembly. But there is no standard subassembly for it. In the other  road design software that I use, there is option to enter the count of the gabbion steps and  wala!..the gabbion wall is added to the assembly with pre-defined parameters which ofcourse can be edited as per requirement. I am really surprised that Civil 3D doesnot have it. Is there a way around? Thankyou..

[Civil3DReminders_com]

You can create your own using Subassembly Composer.

[sb208918]

I haven't had my hands deep on SAC yet, atleast not  to the point where I can enter no. of counts(eg.if n=9, 9 m gabbion wall is added to the assembly). Wouldn't doing so require a loop and to my knowledge, SAC doesn't have this feature added to it so far. So, how can it be done?

[Civil3DReminders_com]

It does have copy and paste and you can copy how ever many steps you think you might require and have an if then statement for each n.

[MikeEvansUK]

Create a subassembly from polyline, Gabions only have set width & heights so just add each one to the subassembly accordingly and get the job done however I advise you to learn SAC for the next time as it can be really helpful.