AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Contributor
jnichol83
Posts: 13
Registered: ‎09-21-2011
Message 1 of 2 (248 Views)

HecRas Import Georefrencing Error

248 Views, 1 Replies
09-19-2012 07:20 AM

Hello,

 

I'm new to exporting from AutoCad Civil3d 2011 to HecRas and I've run into a problem and not sure what the solution is. I export out my alignment, sample lines and surface data to a GEO file and when I try to import it into HecRas it gives me the error that not all my cross sections are georefrenced, its as though the samples lines past a certain point on my alignment aren't georeferenced (according to HeacRas) does anyone have any ideas what the problem is?

Active Member
cwgeary
Posts: 10
Registered: ‎07-08-2011
Message 2 of 2 (242 Views)

Re: HecRas Import Georefrencing Error

09-19-2012 08:22 AM in reply to: jnichol83

I don't know if this will help, but I recently had to do that for a project and was getting a similar error when importing the *.geo file into HEC-RAS.  For me, it was that my cross sections extended past the limits of the TIN.

 

Good Luck,

 

Chris

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.