Hello, I've attached a screenshot of the issue I'm dealing with. I have a closed polyline and when I first hatch the area it appears to be correct, but then I'll go do another command and then the hatch seems to extend beyond the boundaries of the polyline. Any help would be greatly appreciated.
Is the boundary being processed last?
The boundary needs to be at the bottom of the list of operations list. Go to the surface's properties dialog, definitions tab. Use the arrow buttons to move the boundary to the bottom of the list and rebuild.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!