AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Contributor
HC1975
Posts: 36
Registered: ‎01-12-2009
Message 1 of 3 (203 Views)

Ghost TIN lines to Origin

203 Views, 2 Replies
11-22-2011 07:51 AM

I have a corridor surface.  When I start the 3d orbit command tin lines appear from my corridor to the origin point (0,0,0).

 

These ghost tin lines also get rendered in different views.  But they will not show up unless I'm in 3d orbit command so I cannot find a way to edit the tin and delete them.

 

Any suggestions on how I can remove?

 

Thanks,

HC

*Expert Elite*
AllenJessup
Posts: 5,970
Registered: ‎05-21-2003
Message 2 of 3 (200 Views)

Re: Ghost TIN lines to Origin

11-22-2011 08:02 AM in reply to: HC1975

I've seen this be caused by a fault in the assembly or the target that causes an undercut condition along the curb line. Where are those TIN line originating from? Also what version of Civil 3D are you using?

 

Allen

Active Contributor
HC1975
Posts: 36
Registered: ‎01-12-2009
Message 3 of 3 (191 Views)

Re: Ghost TIN lines to Origin

11-22-2011 08:18 AM in reply to: AllenJessup

I am using C3D 2011 32-bit.

 

The ghost tin lines originate from a "slope to surface" subassembly.

 

I've tried turning on all elements in the suface style (points, triangles, etc.).

 

I've also removed the boundary.  Yet the tin lines will only appear in the 3d orbit command or a 3D view.

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.