Getting an Odd Corridor Contour Shifting

[chierchio]

I was curious if anyone has run into a corridor surface shift as shown in the  screen capture.

I was adjusting my alignment and this happened. Ran a drawing audit and everything is fine. Civ3D 64 SP1 on vista 64 bit

any suggestions?

[wfberry]

Is your UCS set to World?

Bill

[Jeff_M]

Looks like you moved your surface, too. Go to the Surface Properties, Definitions. Check if you have a TransformBy shown in the Operation type, if so, delete it. 

[chierchio]

UCS is world, did not move surface. Just moved last segment of alignment a few meters South, re-built corridor and the surface shifted. Tried moving it back and it still stayed in it's shifted state. Closed without saving and trying again 😞

[chierchio]

I actually deleted the surface a couple of times and rebuilt corridor surface and the shift remained. I haven't seen this before.

[Jeff_M]

Could I have a look at the dwg file? I love puzzles....

[dgordon]

try deleting the corridor and starting a new corridor.

Dan

[chierchio]

Unfortunately I can't provide the client's drawing.