Community
There are MANY times that I need to find out the station and offset of a particular location but I don't want to show a label there. The only way I've found to do this is to place a station/offset label and then delete it.
Does anyone know of command that will allow me to use an osnap to find out the station & offset (such as wanting to know the station & offset of the end point of a line, location of a cogo point or center of a circle)?
TIA!
Don Ireland
Engineering Design Technician
If a reply solves your issue, please remember to click on "Accept as Solution". This will help other users looking to solve a similar issue. Thank you.
Please do not send a PM asking for assistance. That's what the forums are for. This allows everyone to benefit from the question asked and the answers given.
OMG! Now that you say that, I remember the instructor quickly skimming over that. But I had forgotten all about it. I've always placed an SO label and then deleted it afterward.
THANKS!
Don Ireland
Engineering Design Technician
If a reply solves your issue, please remember to click on "Accept as Solution". This will help other users looking to solve a similar issue. Thank you.
Please do not send a PM asking for assistance. That's what the forums are for. This allows everyone to benefit from the question asked and the answers given.
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")