My corridor drawing keeps lock up and getting a fatal error. In some cases the drawing becomes unusable and sometimes I can recover it other times I can not. I attached a .png file to show the error.
Just a few questions to give us a little bit more details:
- alfred -
1) I am using Civil 3d 2013 with Service Pack 1
2) Windows 7 64 bit, Intel Core 2.67 GHz Processor, with 8 GB of Memory
3) I have not tried to WBLOCK.
4) Audit showed 19 errors and 19 corrected.
>> I am using Civil 3d 2013
You know that we are here in the forum not for Civil and not for 2013, but for (plain) AutoCAD and 2012?
>> I have not tried to WBLOCK
Then try it.
>> Audit showed 19 errors and 19 corrected
After you ran _AUDIT and it has repaired errors did you crash again?
- alfred -
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!