Editing Corridors with intersections.

[black95gt]

When i adjust my centerline profiles for my centerline of roads, is there a way to get my intersection radius profiles to automatically adjust to the new curb return elevation without going through exporting the new corridor surface and creating a new profile for the radius? or do i just need to go through all this every time i adjust my finished grades.

[Anonymous]

Intersection Builder can make this process a little bit less painful. You
still have to start the dialog so it's not totally automated, but when you
run the command a on an intersection that was previously created with
Intersection Builder, the program will adjust the curb returns based on the
new profile.

Check it out:
http://gis.langan.com/IntersectionBuilder/

A demo version should be available shortly after Civil 3D 2007 is released.



wrote in message news:5135878@discussion.autodesk.com...
When i adjust my centerline profiles for my centerline of roads, is there a
way to get my intersection radius profiles to automatically adjust to the
new curb return elevation without going through exporting the new corridor
surface and creating a new profile for the radius? or do i just need to go
through all this every time i adjust my finished grades.

[Anonymous]

Let's say I want to see this intersection corridor in a section view, is this possible.

[Anonymous]

The Intersection Builder is a simple and fast way to generate curb return
alignments and profiles. In all other regards, the process for grading
intersections would be done by standard Civil 3D procedures (ie: create a
corridor, set up curb return subassemblies, define the regions, etc.)


wrote in message news:5150183@discussion.autodesk.com...
Let's say I want to see this intersection corridor in a section view, is
this possible.