AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Distinguished Contributor
Posts: 121
Registered: ‎05-09-2008
Message 1 of 2 (164 Views)

Editing a pipe size in an existing network parts list

164 Views, 1 Replies
01-07-2013 11:36 AM

I am using C3D 2012. I have a pipe network catalog located on our office network server. I have a pipe size shown as 15" that is incorrect, it should read and label the pipe as 16" (see attached image). I don't know a lot of the workings how to edit this from 15 to 16 inch and what I need to do to get it correct for the other C3D users in the office. If some one has step through directions it would be much appreciated.


Thanks for the help

*Expert Elite*
Posts: 1,390
Registered: ‎09-05-2007
Message 2 of 2 (146 Views)

Re: Editing a pipe size in an existing network parts list

01-07-2013 01:15 PM in reply to: jak79

If you want, you can add a part family for Ductile Iron Pipe.  There is a 16" in there.  If not, you will have to create the size from the Part Builder.

If the issue was resolved by this method, please click on "Accept As Solution"
*Civil 3DJ*
Todd Rogers

Visit my blog here.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.