AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
*Robert
Message 1 of 2 (58 Views)

Editing a corridor surface

58 Views, 1 Replies
04-15-2005 09:49 AM
The attached drawing is an attempt to regrade an existing road and add a
ditch on either side of the roadway. The problem that I am running into is
when the road passes the high point. As can be seen from the drawing, the
contours extend 100' outside of the road. It appears that the surface
created on the corridor has some extra tin lines...Can these be deleted?
Am I doing something else wrong? Thanks.
Robert Skrobot
Employee
nzeeben
Posts: 1,102
Registered: ‎01-30-2004
Message 2 of 2 (58 Views)

Re: Editing a corridor surface

04-15-2005 10:44 AM in reply to: *Robert
I tried what you posted in customer files, drawing file is not valid, the size is 1.01mb, not sure if that is the whole thing? Message was edited by: nzeeben
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.