AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
*Landman
Message 1 of 1 (54 Views)

Dynamic update of a surface in a Profile

54 Views, 0 Replies
12-13-2004 08:06 AM
Good Day All. I am first going to try to explain the problem I am having. Lets say we have a road alignment running from top center of your coumputer monitor to the bottom center. From that alignment we have another one running from the midpoint perpendicular the right edge of your monitor. So basically we have a tee intersection. I have created a surface from align 1 (running top to bottom) and then cut another profile from alignment 2 (Mid to perp of right edge of screen). I then had to revise the first profile: Question: Should or is it possible to have ther first surface dynamically updat on the second profile. On the second profile the first surface would be represented by a cross section. Thanks. Hope I was able to explain this well enough.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.