AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Distinguished Contributor
Posts: 160
Registered: ‎09-07-2006
Message 1 of 2 (249 Views)

dragged state alignment station offset label

249 Views, 1 Replies
10-07-2013 10:17 AM

I would like to set up an alignment station offset label that when in the dragged state, offsets the arrowhead from the actual insertion point on the alignment in any direction and distance I specify. I am preparing some plans for a water line. I am working at a 1"=200' scale so all of the blocks representing fittings are scaled up so they are legible. In some instances, the fittings are right next to each other. If I place an alignment station offset label at the actual station and drag it away from the alignment, the arrowhead is pointing to the station but not the fitting. Is there a way to offset the arrowhead of a C3D label in dragged state other than in the direction of the leader?


Thank you for your help.

Posts: 224
Registered: ‎12-19-2006
Message 2 of 2 (215 Views)

Re: dragged state alignment station offset label

10-08-2013 06:43 AM in reply to: demus72

The station offset label appears to be performing as designed. You are pointing to station 10+04 and that is what is being labeled. Your gate valve is not at station 10+04 due to the scaling of the block.


I suspect that you want to label it as 10+04 new gate valve and have it point to a point that is not at sta 10+04.


that is not possible.


What you could do is label it and not show the leader at all. IF you needed you could draw some dumb linework to the valve.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.