Community
Civil 3D Forum
Welcome to Autodesk’s Civil 3D Forums. Share your knowledge, ask questions, and explore popular AutoCAD Civil 3D topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Ditch subassembly that keeps 3:1 slope

3 REPLIES 3
SOLVED
Reply
Message 1 of 4
Topher5000
418 Views, 3 Replies

Ditch subassembly that keeps 3:1 slope

I need to make a ditch subassembly that will keep a 3:1 foreslope while I change the elevation of the ditch.  I've tried LinkOffsetAndSlope, LinkWidthAndSlope, LinkSlopeToElevation, DaylightGeneral, DaylightBasin, DaylightStandard & BasicSideSlopeCutDitch but nothing works.  If it follows the ditch grades, it keeps the width or offset & changes the 3:1 slope.

I've been wracking my brain with this for some time now.  What's the easiest way to do this?

3 REPLIES 3
Message 2 of 4
fcernst
in reply to: Topher5000

LinkSlopeAndVerticalDeflection



Fred Ernst, PE
C3D 2024
Ernst Engineering
www.ernstengineering.com
Message 3 of 4
Topher5000
in reply to: fcernst

Hi fcerst.  Could explain the parameters please?  I tried but couldn't figure it out.

Message 4 of 4
Topher5000
in reply to: Topher5000

I think I got it.  I'll try it out & if I have any problems, I'll post back.  If not, I'll accept as the solution.  Thanks.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Rail Community


Autodesk Design & Make Report