AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
*Expert Elite*
KMercier_C3D
Posts: 255
Registered: ‎12-14-2010
Message 21 of 22 (140 Views)

Re: ditch profile & alignment assembly question

01-02-2013 06:30 AM in reply to: nostupidquestions

If you switch from the Roadway mode to the Layout mode in Subassembly Composer's Preview pane then you should see what it will look like when inserted into a subassembly in Civil 3D. This setting ignores all targets for calculation purposes since there are no targets associated with an assembly prior to being part of a corridor. You will need to change some of your default values that the targets override in order to get a link to display (you will want to change a 0 somewhere). 

Kati Mercier, P.E.

Co-author of "Mastering AutoCAD Civil 3D 2013"
AutoCAD Civil 3D 2013 Certified Professional and AutoCAD 2013 Certified Professional
AU2012 Speaker::: CI3001: Reverse Engineering with Subassembly Composer for AutoCAD Civil 3D
AU2011 Speaker::: CI4252: Create Subassemblies That Think Outside the Box With Subassembly Composer for AutoCAD® Civil 3D®
Distinguished Contributor
nostupidquestions
Posts: 469
Registered: ‎11-17-2005
Message 22 of 22 (134 Views)

Re: ditch profile & alignment assembly question

01-02-2013 06:55 AM in reply to: KMercier_C3D

sweet! that got it. thank you very much.

i listened to the 2 presentations about the subassembly composer and i followed what was going on but to learn it i think i need something a little more basic. any recommendations?

Dell Studio XPS 9100
Intel Core i7 CPU 930 @ 2.8GHz
12GB Ram
64 bit
C3D 2015
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.