AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Member
dyoxyne
Posts: 6
Registered: ‎01-06-2013
Message 1 of 3 (434 Views)

Different alignment offsets with the same profile

434 Views, 2 Replies
01-10-2013 05:13 PM

Hello,

 

I created a profile for an alignment (which has 2 offsets) and also an assembly with two assembly offsets.

I wanted to create a corridor where my assembly offsets will have the same profile but will be on different alignments  (alignment offsets).

 

In the corridor properties / parameters, I got an error : duplicate profile found.

 

Should I copy the profile (for each offset) in different profile views (for each offset) ? Or there is a better way to do that ?

Thank you.

Active Member
dyoxyne
Posts: 6
Registered: ‎01-06-2013
Message 2 of 3 (418 Views)

Re: Different alignment offsets with the same profile

01-10-2013 07:03 PM in reply to: dyoxyne

One more question, the alignment offset has a type : offset (logical) but I can't apply cant to it.
I changed it to : Rail but I don't think it's a good way.

Anyone knows ?

*Expert Elite*
Adriano_cad
Posts: 105
Registered: ‎06-21-2011
Message 3 of 3 (394 Views)

Re: Different alignment offsets with the same profile

01-11-2013 09:06 AM in reply to: dyoxyne

Hello

 

To use a project profile on an offset alignment, you need to create the profile of the surface for the alignment offset, and then use the command _AeccSuperimposeProfile to profile the central alignment be used in Offset.

 

bye

Adriano Oliveira

*Expert Elite*
MaxiCAD Informática
www.maxicad.com.br
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.