Description key symbols not rescaling.

[terry231]

I've imported my points from a .CSV file. The description keys worked great, I have symbols on the points that need them. The drawing scale is set to 1"=20'. I've plotted it out at 20 scale and it looks fine. My problem is that when I change the viewport scale to 1"=40' and plot the drawing the symbols remain the same size. Is this normal or do I have a setting wrong?

[rl_jackson]

Go into your Point Styles and verify that on the Marker Tab, the Size is set to Use drawing Scale (Upper right)

See Below:

[rl_jackson]

Also, the size that they symbol will be in the Y direction only so a symbol that is not symmetrical, will need some adjustment to get your desired look

[terry231]

It is set to "use drawing scale"

[rl_jackson]

Check you Description Key's is Scale Parameter Column, is Parament 1 checked?

[terry231]

that is checked.

[kcobabe]

Are your blocks Dynamic or Annotative?  Try turning that off as I have had this happen with blocks that had both features.  Once I made them legacy blocks the probalem was no longer there.

[rl_jackson]

Never had that issue myself, and I have tons of blocks that are dynamic just in case it's something that can't be shot but can be chained.

I at a loss as to what could be the OP's issue. Maybe post a drawing, this has to be something simple.