Is there a way to show the deflection angle between incoming and outgoing pipes in a structure label? Or any label at all, for that matter? I know it can be done with alignments at the PI point, but only in the source drawing.
Thanks in advance.
I realize this is an old post but searching for newer post didn't reveal much on the topic.
Has anyone been able to come up with a solution for this?
This is something we are needing for one of our projects. I would hate to manually add this to the label but so far that looks like it might be the quickest solution so far. That or create an alignment for all the pipe runs and use the PI label example shown on another post.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!