I have a fairly simple corridor, however, I had to modify the alignment, rebuild the corridor and resample cross-sections. Now my right daylight slope won't show up. It shows up in the section viewer, but not the cross-section. I had this problem once before and fixed it, but now I can't remember how I did...I have all targets, sections sampled match corridor sampling etc. Any help appreciated, thanks.
Civil 3D 2012 SP1
maybe empty the drawing except for a sample of the corridor where this is happening. someone will figure out what is going on.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!