AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Contributor
w10896
Posts: 21
Registered: ‎07-07-2011
Message 1 of 2 (195 Views)
Accepted Solution

Datum connection

195 Views, 1 Replies
02-02-2012 03:15 PM

Hi All,

 

Please see attachment of cross section.   My datum jumps up to the point where my subassembly (ShapeTrapezoidal) connects to the back of curb.  What do I need to change so the datum will connect and go vertical to the bottom of the subassembly after the curb extension?

Valued Mentor
awood
Posts: 313
Registered: ‎06-24-2005
Message 2 of 2 (191 Views)

Re: Datum connection

02-02-2012 03:21 PM in reply to: w10896

In the Corridor Properties - Surfaces tab - set the Overhang correction for the datum surface to bottom links and see if that helps.

 

HTH

AWood

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.