cut/fill area problems in section views

[DavidTremblay1879]

After have done the "compute material" command in the section menu, the cut and fill area became green and red in the section views.
But, the area aren't complete. For example, in a cut section, the cut area appear red until the beginning of the ditch and there is no area after. So the cut area of ditch aren't include in the volume.

Any ideas????

Thank!

Émilie

[Anonymous]

First thing I would check is whether your datum surface actually exists out
past that point.

--
Matt Kolberg
Global CADD Systems - A division of Cansel

"DavidTremblay1879" wrote in message news:6350890@discussion.autodesk.com...
> After have done the "compute material" command in the section menu, the
> cut and fill area became green and red in the section views.
> But, the area aren't complete. For example, in a cut section, the cut area
> appear red until the beginning of the ditch and there is no area after. So
> the cut area of ditch aren't include in the volume.
>
> Any ideas????
>
> Thank!
>
> Émilie

[DavidTremblay1879]

Thank Matt,

That's not a surface problem because all section views have this problem. And there is a part of the area of each section who is include in the volume. The problem is that it's not the complete area.

?????????????Help me please?????????????????

Émilie

[Anonymous]

Attach the file. If it's not small enough either make it smaller or attach
it to the customer files group and get us a link.

--
Matt Kolberg
Global CADD Systems - A division of Cansel

"DavidTremblay1879" wrote in message news:6351313@discussion.autodesk.com...
> Thank Matt,
>
> That's not a surface problem because all section views have this problem.
> And there is a part of the area of each section who is include in the
> volume. The problem is that it's not the complete area.
>
> ?????????????Help me please?????????????????
>
> Émilie

[DavidTremblay1879]

I found my mistake! All the P codes of subassemblies was P2 or P40. I changed them for all differents names, and then almost all my sections was correct. After, I changed the beginning stations of some region who was the same that the end of other.

Émilie