AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Member
5 Posts
0 Kudos
Registered: ‎01-24-2013
Post 1 of 6

Cut and fill to specific elevation (BFE)- For FP Mitigation

390 Views, 5 Replies
01-29-2013 07:57 AM

I need to figure out the amount of cut and fill up to a specific elevation, the Base Flood Elevation.  Right now, I am creating the proposed and existing surfaces in Civil 3D and making a fellow coworker convert it to Eagle Point to generate this slice Volume Table. See attached PDF.  Is there a way to generate this type of table in Civil 3D? Any ideas?  Thank you!

*Expert Elite*
1,397 Posts
169 Kudos
Registered: ‎09-05-2007
Post 2 of 6

Re: Cut and fill to specific elevation (BFE)- For FP Mitigation

01-29-2013 09:41 AM in reply to: amybrammer10

Is this what you're looking for?...

 

4-4-2012 8-46-10 AM.png

 

This can be exported out to a TXT file.

If the issue was resolved by this method, please click on "Accept As Solution"
*Civil 3DJ*
Todd Rogers

Visit my blog here.

     
Valued Contributor
81 Posts
4 Kudos
Registered: ‎10-24-2008
Post 3 of 6

Re: Cut and fill to specific elevation (BFE)- For FP Mitigation

01-29-2013 10:44 AM in reply to: amybrammer10

Another option is to set a user contour to your required elevation.  Extract the contour as a polyline and use it/them as a boundary.  Even if the boundary is only temporary.

You may have to edit them a bit to get the desired results.

 

Conan Witzel

Member
5 Posts
0 Kudos
Registered: ‎01-24-2013
Post 4 of 6

Re: Cut and fill to specific elevation (BFE)- For FP Mitigation

09-16-2013 01:24 PM in reply to: TRogers

Yes but how do I compare the existing and proposed surfaces? It only allows me to select one of the surfaces. Thank you for your help!

Member
5 Posts
0 Kudos
Registered: ‎01-24-2013
Post 5 of 6

Re: Cut and fill to specific elevation (BFE)- For FP Mitigation

09-16-2013 01:29 PM in reply to: amybrammer10

I am trying to do a volume comparison between the proposed and existing surfaces and have to show the cut/fill volumes in one foot increments. 

*Expert Elite*
1,397 Posts
169 Kudos
Registered: ‎09-05-2007
Post 6 of 6

Re: Cut and fill to specific elevation (BFE)- For FP Mitigation

09-16-2013 01:33 PM in reply to: amybrammer10

Type REPORTSURFACEVOLUME and you can get a volume that way.

If the issue was resolved by this method, please click on "Accept As Solution"
*Civil 3DJ*
Todd Rogers

Visit my blog here.

     
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post