AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Member
amybrammer10
Posts: 5
Registered: ‎01-24-2013
Message 1 of 6 (379 Views)

Cut and fill to specific elevation (BFE)- For FP Mitigation

379 Views, 5 Replies
01-29-2013 07:57 AM

I need to figure out the amount of cut and fill up to a specific elevation, the Base Flood Elevation.  Right now, I am creating the proposed and existing surfaces in Civil 3D and making a fellow coworker convert it to Eagle Point to generate this slice Volume Table. See attached PDF.  Is there a way to generate this type of table in Civil 3D? Any ideas?  Thank you!

*Expert Elite*
TRogers
Posts: 1,390
Registered: ‎09-05-2007
Message 2 of 6 (359 Views)

Re: Cut and fill to specific elevation (BFE)- For FP Mitigation

01-29-2013 09:41 AM in reply to: amybrammer10

Is this what you're looking for?...

 

4-4-2012 8-46-10 AM.png

 

This can be exported out to a TXT file.

If the issue was resolved by this method, please click on "Accept As Solution"
*Civil 3DJ*
Todd Rogers

Visit my blog here.

     
Valued Contributor
witzel
Posts: 81
Registered: ‎10-24-2008
Message 3 of 6 (354 Views)

Re: Cut and fill to specific elevation (BFE)- For FP Mitigation

01-29-2013 10:44 AM in reply to: amybrammer10

Another option is to set a user contour to your required elevation.  Extract the contour as a polyline and use it/them as a boundary.  Even if the boundary is only temporary.

You may have to edit them a bit to get the desired results.

 

Conan Witzel

Member
amybrammer10
Posts: 5
Registered: ‎01-24-2013
Message 4 of 6 (235 Views)

Re: Cut and fill to specific elevation (BFE)- For FP Mitigation

09-16-2013 01:24 PM in reply to: TRogers

Yes but how do I compare the existing and proposed surfaces? It only allows me to select one of the surfaces. Thank you for your help!

Member
amybrammer10
Posts: 5
Registered: ‎01-24-2013
Message 5 of 6 (232 Views)

Re: Cut and fill to specific elevation (BFE)- For FP Mitigation

09-16-2013 01:29 PM in reply to: amybrammer10

I am trying to do a volume comparison between the proposed and existing surfaces and have to show the cut/fill volumes in one foot increments. 

*Expert Elite*
TRogers
Posts: 1,390
Registered: ‎09-05-2007
Message 6 of 6 (228 Views)

Re: Cut and fill to specific elevation (BFE)- For FP Mitigation

09-16-2013 01:33 PM in reply to: amybrammer10

Type REPORTSURFACEVOLUME and you can get a volume that way.

If the issue was resolved by this method, please click on "Accept As Solution"
*Civil 3DJ*
Todd Rogers

Visit my blog here.

     
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.