I need to figure out the amount of cut and fill up to a specific elevation, the Base Flood Elevation. Right now, I am creating the proposed and existing surfaces in Civil 3D and making a fellow coworker convert it to Eagle Point to generate this slice Volume Table. See attached PDF. Is there a way to generate this type of table in Civil 3D? Any ideas? Thank you!
Is this what you're looking for?...
This can be exported out to a TXT file.
Another option is to set a user contour to your required elevation. Extract the contour as a polyline and use it/them as a boundary. Even if the boundary is only temporary.
You may have to edit them a bit to get the desired results.
Yes but how do I compare the existing and proposed surfaces? It only allows me to select one of the surfaces. Thank you for your help!
I am trying to do a volume comparison between the proposed and existing surfaces and have to show the cut/fill volumes in one foot increments.
Type REPORTSURFACEVOLUME and you can get a volume that way.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!