Can one assume that you have the "Transparent Commands" toolbar visible?
There are a few tools there & using them with regular AutoCad commands, most
any configuration can be accomplished. The easiest one is to use the fillet
(radius) command.
Bill
"soundengine" wrote in message
news:12414895.1107992237398.JavaMail.jive@jiveforum2.autodesk.com...
> Hello.. Drawing up a property boundary that happens to consist of many
curves. In my old Cad, R14, I could draw the Radial to the curve, and then
do a "Curve off One Tangent" and draw the curve by punching in the
Delta/Length, and Radius.. In Civil 3d, I cant seem to find anyway where to
draw Curves off Tangents, or between 2 tangents, or anything remotely close
to what used to be on R14. In fact, it took me three days just to figure
out how to do Lines By Direction. And, that was by typing "Line", the
typing 'BD. PLease, someone, tell me there is an easier way...
>
> Thanks,
> =-Ben