AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
New Member
thijs.van.loon.94
Posts: 1
Registered: ‎06-18-2013
Message 1 of 2 (168 Views)

Cursor does not want to leave modelspace

168 Views, 1 Replies
06-18-2013 01:34 PM

Good evening, 

 

I am encountering a problem using AutoCAD Civil 3d 2012. When finishing a certain command and going back to the ribbon, my cursor does not want to go out of the modelspace. So i can't click any command in the ribbon, or in any other program outside of AutoCAD. 

 

Even when pressing escape to stop a command, nothing changes. Using the viewcube solves this problem for one time. But every time I draw a line or even zooming, the problem comes back again. This is very annoying. 

 

Hopefully anyone can help me. Thanks in advance.

Thijs

Product Support
Karsten.Saenger
Posts: 168
Registered: ‎12-07-2012
Message 2 of 2 (132 Views)

Re: Cursor does not want to leave modelspace

06-19-2013 02:20 AM in reply to: thijs.van.loon.94

It is hard to give suggestions without more information.
- Is it always the same "certain" command - and which is it?
- Is the cursor still visible or disappearing?
- Can we exclude hardware problems, especially graphics card issues? See http://usa.autodesk.com/adsk/servlet/syscert?id=18844534&siteID=123112
- A early solution for a similar issue was do turn off snapping - it's worth a try.




Karsten Saenger
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.