AutoCAD Civil 3D General Discussion

Distinguished Contributor
Posts: 231
Registered: ‎01-27-2011
Message 1 of 2 (104 Views)

Cross Sections

104 Views, 1 Replies
04-28-2013 01:24 PM

I have some cross sections showing existing and finished grade. The finished grade is a channel and floodplain with slopes to catch existing ground. I’d like to create a report of the offset and elevation at each grade break for the finished grade. Optionally, it could be offset and cut or fill at each grade break. I’ve found the tool to create annotation for the offset and elevation info, but the cross sections are too small on the drawings to accommodate all that text. Is there a way to generate a report for the section view group or even each section view that would contain that information?

*Expert Elite*
Posts: 2,117
Registered: ‎11-08-2005
Message 2 of 2 (90 Views)

Re: Cross Sections

04-28-2013 05:09 PM in reply to: martin888888

If the channel was created from a corridor then you may be able to use one of the reports in the Toolbox tab of the Toolspace dialog.  Expand the Corridors group and try the Feature Line or the Section Points report.


Please use the Accept as Solution or Kudo buttons when appropriate

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.