AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Mentor
trynders
Posts: 467
Registered: ‎12-10-2003
Message 1 of 2 (154 Views)

Cross Sections and modeling

154 Views, 1 Replies
01-16-2013 08:30 AM

Please help.

I am working on modeling a road that has a varying curb line on one side.  The sidewalk is to remain at a set distance from the centerline.  So the tree lawn is changing width.  How do I or what do I use to create an assembly to show that.  I have already created a horizontal alignment so the edge of pavement and curb follow it.  I have placed a urban sidewalk at the specified distance.  It just changes elevation with the centerline profile.  my road sub assembly is set to change width and hold grade.  so as the edge of pavement moves in, the elevation is raising.  btw, the cross section is a 2% cross slope.  Hope this makes sence.  I dont quite get all the linked offset to stuff assemblies.  I have attached a picture of the tree lawn section.  The tree lawn needs to match to grade on the opposite side of the sidewalk.  (2%).

*Expert Elite*
Joe-Bouza
Posts: 4,951
Registered: ‎12-15-2008
Message 2 of 2 (139 Views)

Re: Cross Sections and modeling

01-16-2013 09:16 AM in reply to: trynders

add an alignment for the front of sidewalk and add thae target to the sw sub. if you are holding existing you can profile it too.

 

If I'm hearin ya right?

Thank you

Joseph D. Bouza, P.E. (one of 'THOSE' People) Civil 3D 2012 & 2013
HP Z210 Workstation
Intel Xeon CPU E31240 @ 3.30 Hz
12 GB Ram


Note: Its all Resistentialism, so keep calm and carry on

64 Bit Win7 OS
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.