AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Valued Contributor ces
Valued Contributor
ces
Posts: 56
Registered: ‎12-12-2007
Message 1 of 2 (125 Views)
Accepted Solution

corridor surface not linking to existing surface

125 Views, 1 Replies
04-17-2014 06:40 AM

I have created a corridor and a surface from the corridor that looks fine from R/W to R/W...however it seems to disreguard my existing surface...I am using "link slope to furface" at 3:1 for both cut and fill...I have specified my target surface as my existing surface...I have specified top links for overhang correction...horizontally and vertically I have way more than enuf existing surface to daylight to...I have never had this problem before, any thoughts, ideas or insight will be gratefully received...

 

thanks

ces

nevermind, I figured it out...

 

 

thanks,

shep

Valued Contributor ces
Valued Contributor
ces
Posts: 56
Registered: ‎12-12-2007
Message 2 of 2 (110 Views)

Re: corridor surface not linking to existing surface

04-17-2014 08:25 AM in reply to: ces

nevermind, I figured it out...

 

 

thanks,

shep

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.