AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Active Contributor
dbussie
Posts: 43
Registered: ‎08-08-2013
Message 1 of 5 (296 Views)

Corridor Surface Ignoring Vertical Link

296 Views, 4 Replies
11-06-2013 01:17 PM

For some reason the surface created by my corridor is ignoring the vertical link on the edge of the subassembly.  How can I get it to include that?

Desirea
FBL & Associates
Civil 3D 2014

*Expert Elite*
lholland
Posts: 2
Registered: ‎01-18-2013
Message 2 of 5 (292 Views)

Re: Corridor Surface Ignoring Vertical Link

11-06-2013 01:34 PM in reply to: dbussie
Don't forget to set your overhang correction to "Bottom Links" that'll do the trick.
Active Contributor
dbussie
Posts: 43
Registered: ‎08-08-2013
Message 3 of 5 (288 Views)

Re: Corridor Surface Ignoring Vertical Link

11-06-2013 01:51 PM in reply to: lholland

It is set to Bottom Links and is still ignoring it.  Could it be because it is on the edge?

*Expert Elite*
mathewk
Posts: 2,753
Registered: ‎07-09-2003
Message 4 of 5 (266 Views)

Re: Corridor Surface Ignoring Vertical Link

11-06-2013 04:56 PM in reply to: dbussie
Try Top Links instead (overhang correction).
Matt Kolberg
Cansel - Autodesk Division
http://www.cansel.ca/
Active Contributor
dbussie
Posts: 43
Registered: ‎08-08-2013
Message 5 of 5 (231 Views)

Re: Corridor Surface Ignoring Vertical Link

11-07-2013 06:11 AM in reply to: mathewk

This is strange.  That worked for the left side but didn't work on the right side.

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.