AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
Member
4 Posts
0 Kudos
Registered: ‎01-03-2013
Post 1 of 4

Corridor Problem, target options

225 Views, 3 Replies
01-19-2013 05:06 PM

I followed all the instructions.  But I still have this problem. 

 

Value on wrong side of alignment or profile Target corridor

*Expert Elite*
2,872 Posts
266 Kudos
Registered: ‎04-27-2005
Post 2 of 4

Re: Corridor Problem, target options

01-19-2013 09:29 PM in reply to: sakuramukuro

It looks like you have two daylight subassemblies, one on each side, and you have them both targeting the same profile. Most likely your profile is one one side of your assembly so the other side can't target it.

Brian Hailey
CAD-1.com
My Blog
*Expert Elite*
2,289 Posts
418 Kudos
Registered: ‎11-08-2005
Post 3 of 4

Re: Corridor Problem, target options

01-19-2013 10:05 PM in reply to: BrianHailey

Interesting.  I would have assumed that a target controlling elevation would not care about which side the reference alignment was on.  I also noticed that the warning is coming from the subassemblies on both sides.  It would make more sense if it was complaining about one side only.

*Expert Elite*
2,872 Posts
266 Kudos
Registered: ‎04-27-2005
Post 4 of 4

Re: Corridor Problem, target options

01-20-2013 09:15 AM in reply to: sboon

sboon wrote:

Interesting.  I would have assumed that a target controlling elevation would not care about which side the reference alignment was on.  I also noticed that the warning is coming from the subassemblies on both sides.  It would make more sense if it was complaining about one side only.


I didn't look at it real close. I just saw that both sides were targeting the same profile and I just threw that out as an option. I've never tried to target a profile that wasn't on the same line as what I was targeting horizontally. You know what they say, when you pressume, you make a press out of... never mind. :smileyhappy:

Brian Hailey
CAD-1.com
My Blog
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post