AutoCAD Civil 3D General Discussion

AutoCAD Civil 3D General Discussion

Reply
New Member
jhamer
Posts: 2
Registered: ‎08-19-2013
Message 1 of 3 (309 Views)

Corridor Assembly Target Issues

309 Views, 2 Replies
10-08-2013 08:31 AM

Ive created an access road and there is a section where the road width flares out so i am targeting the polylines imported from the 2d layout. However when i target these polylines there is part of the corridor region which doesnt target the polylines correctly it is overshooting the polyline. However the same corridor region and targeting same polyline slightly firther north correctly targets the polyline, please see images attached. The sub assumbly i am using the the lane outside super with widening

Valued Mentor
david.zavislan
Posts: 282
Registered: ‎10-31-2006
Message 2 of 3 (230 Views)

Re: Corridor Assembly Target Issues

10-09-2013 08:01 AM in reply to: jhamer

My guess is that the LaneOutsideSuperWithWidening subassembly is calculating the width based on the alignment's superelevation parameters, which may be overriding the target offset.  I have never used that subassembly, so I suggest you read it's help document for more information. 

 

I typically use the LaneOutsideSuper subassembly instead.  It does not calculate widening, but will let you attach offset targets to transition the width.

David Zavislan, P.E. | Wood Rodgers, Inc.
*Expert Elite*
sboon
Posts: 2,226
Registered: ‎11-08-2005
Message 3 of 3 (222 Views)

Re: Corridor Assembly Target Issues

10-09-2013 08:28 AM in reply to: jhamer

Is the corridor just ignoring the polylines completely in the problem section and using a default width, or is it going a specific distance beyond the polyline?  Is the polyline segment a curve or is it straight at this location?  What happens if you add a few PIs to the polyline in this area?

 

Steve
Please use the Accept as Solution or Kudo buttons when appropriate

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.